Wattcellar

Can a power station run a space heater?

For minutes to a couple of hours. A 1,500 W heater on high empties a 1,070 Wh station in about 36 minutes. Pick your heater and setting to see the time, and which stations can put out the watts at all.

Last updatedOct 18, 2026

Heater ratingsLasko and De'Longhi product pages and manuals, read Oct 18, 2026

Your heater and station

Your heater

Station

Result

0h

    The math

    Every station against this heater

    Time from full at your setting. Gray rows can't put out the heater's watts. The shaded row is the smallest station in our table that runs it. Prices are what each maker's US store showed on Oct 18, 2026.

    Links marked “affiliate link” go through Awin to that maker’s US store (Jackery or BLUETTI); if you buy, the maker may pay us a commission at no cost to you. It never changes the hours, the checks or which row is shaded. Affiliate disclosure.

    Every station in our table against this load
    StationCapacity, WhRuns it forAC output, WSurge, WStore priceVerdict

    Heater ratings we read

    Maker ratings, read Oct 18, 2026. Heat out = watts × 3.412 Btu per watt-hour (EIA)
    HeaterSettingWattsHeat out, Btu/hMinutes per 1 kWh usable

    A 1,070 Wh station gives about 910 Wh usable at Jackery's 0.85 factor. Every electric resistance heater turns its watts into the same heat, so a 1,500 W ceramic heater and a 1,500 W oil-filled radiator drain a station equally fast.

    How the time is worked out

    Hours = capacity × share you can use × efficiency ÷ (heater watts × share of time on + station idle draw). The heater figure is the maker's rating for that setting. A resistance heater draws close to its rating whenever its element is on and has no motor to start, so the output check compares the rating with the station's continuous AC output and no start-up surge is added. Heat output uses the EIA conversion of 3,412 Btu per kilowatt-hour (EIA). Sources are on Methods and sources.

    A station is a poor way to heat a room for long: a heater on high takes more power than anything else on our appliance list, more than a microwave. If you have a gas furnace, the station only has to run its blower, which takes far less; see a gas furnace on a power station.